to follow, share, and participate in this community.
Hi everyone. Dumb question for NEWB here. I can't figure out what I need to be able to configure our new MX2820. I am having issues connecting to the SCU. I have a DB9/ USB to serial adapter and access... I'm being asked by a cable vendor, 'what kind of BNC connector, and what kind of coax is needed?'. This is not something spelled out in the MX2800 user guide. Does anyone know the specific cable specifications for the... Are 1186003L5 and 1186002F3 still available or have they reached end-of-life? If so, what were the end-of-life dates? I believe I have two issues but would like to confirm. First I have an automated check running that will PING the hosts as well as initiate an SSH session, I am assuming from my reading this controller has no ... I thought I had lost remote access to a 2820. I can ping the IP without issue, but when I tried to telnet to it, I just got a blank screen. I could type on the screen but it appeared that nothing was happening. I noti... I have several Adtran MX2800 devices and my company has disconnected all the circuits to the device. I need to decommission them, but our physical removal teams won't remove anything that has power to it. How do you p... Can I use 1204288L2 and 1205288L2 in the same Mux? i HAVE A SET OF 2820'S ON RANDOM OCCASIONS THE DS1 WILL ALL SHOW LOOP WHEN TESTING AND ALL CUSTOMER TRAFFIC DROPS AND THEY COMPLAIN OF SEEING WHEN TESTING BACK TOWARDS THE MUX. iT START WITH ONE MUX IN A SHELF AND SOO... My MX2800 was installed without notice and I was never given the User iD or Password. I now need to correct the provisioning from C-Bit to M13 but I cannot access it. how can I revert everything to default... I need to order some of the db-9 connectors for console access to a MX2820. Would part number 3196ADPT001 work? It appears that release notes for MX 2820 SCU firmware are not available from software downloads. We have three 2820s, and all three SCUs are woefully out of date (E02 and F01). Does anyone have a FW upgrade path, or ... I'm trying to connect a 2800 to a Comm Router. I see the pin outs for RJ45 to DB9, but not sure if it stays RJ45 to RJ45, would it be a cross over or straight through? I recently worked with an MX2820 customer experiencing intermittent loss of Telnet/Remote access via LAN IP. This particular customer informed me they'd recently upgraded their LAN/IP Network with new routers.... Is rebooting the MX2820 SCU card service affecting? I have an MX2800 that is no longer giving me access to the unit. The user interface is not coming up, I have the username and password. But there is no screen promt. What is my next step or steps? Is there a way for... I am trying to figure a way to automate pulling data from our MUXs, they are all MX2820 models. Basically what I am looking for is some way to gain access to shell or an API that I can use to send commands to the syst... Just received MX2820 with M13 mux's. We were told that we could drop and insert DS1's with these devices out of a DS3. Just getting familiar with them. Looks like we have to bring all 28 out of each ... So we have several MX2820's all running with an SCU card. Only one of the 2820's can no longer be accessed over Ethernet and connecting via USB to Serial cable does not work. We have changed cables, checke... Is there a visio stencil for the MX2820 (19") version? We have two of these at diverse sites and I need to update the network diagrams.
Get a feed of this content