• Removing or Editing Secondary Interface on 3140:

    I have a netvanta 3140 with some pretty hefty config.  I inherited this, but I think one of my secondary public IPs Subnet is wrong.  My main subnet is x.x.x.x 255.255.255.240 mask.  All of the secondar...
    daremo18
    last modified by daremo18
  • NV3140 High cpu usage when used for a sip trunk

    NV3140 being used for a SIP Trunk Issues are intermittent fast busy when calling out, and possibly some incoming calls failing.  Secondary issue is the customer is trying to use a fax service across this, which ...
    brian.carnett
    last modified by brian.carnett
  • 3140 with EFP - Disable SIP ALG?

    Have a 3140 with EFP, not utilizing any SIP functionality on the platform other that QOS for SIP running thru the router.   Can SIP ALG be disabled?  Can SIP the SIP functionality be disabled globally? ...
    jtarkington
    last modified by jtarkington
  • Local or Network modes on SIP Trunk

    On a SIP Trunk (using a NV3140) what is the recommendation for setting the transfer, forward, and feature modes?  Local or Network? Should this be set globally or within each SIP Trunk (one trunk faces the provi...
    jkesting
    last modified by jkesting
  • comcast

    Has anyone ever setup a netvana 3140 SBC with comcast sip services? They are stating that if we use a netvana, it must emulate a PBX in order for their services to work. Does anyone know what they are talking about?
    whitehat
    last modified by whitehat
  • Initial config of netvanta 3140

    Hi there, I'm hoping this is a simple(r) question.   We are a small tech support company, and are pretty technically proficient, but we are normally dealing with routers such as barracuda/sonicwall/ubiquity. A p...
    realmx2
    last modified by realmx2
  • What kind of throughput can I expect on a NetVanta 3140 with firewalling disabled?

    I'm trying to figure out what kind of throughput I am going to get with a 3140. The firewall will be disabled and there are no VPNs, but it will be doing QoS. Can I expect higher than the 600Mbps on the product matrix...
    kevin_b79
    last modified by kevin_b79
  • WAN Failover issue with NV3120

    I have setup WAN fail-over on NV3120. The primary is Comcast and backup WAN is FIOS. The fail-over works and when Comcast goes down it fails to FIOS as expected.  But the problem is when Comcast link comes back...
    raj301
    last modified by raj301
  • I have an Adtran 3140 (PN 1700341F1) and need to perform a hard reset (cannot log in).  There does not appear to be a reset button.  Are there any alternatives?

    I have an Adtran 3140 (PN 1700341F1) and need to perform a hard reset (cannot log in).  There does not appear to be a reset button.  Are there any alternatives?
    albeewankanobe
    last modified by albeewankanobe
  • How to setup WAN internet failover between Comcast and FIOS Link ?

    I have a NetVanta 3140 (ver.13.5.1) and I am looking to configure WAN internet fail over between Comcast and FIOS internet link. Comcast interface is on static IP but FIOS interface is on DHCP. Any sample configurat...
    raj301
    last modified by raj301
  • port forwarding 3120

    need to set port forwarding on 3120
    jmayvil
    last modified by jmayvil
  • Dual Homed Setup

    Hello,   We have two ISP's that we Peer with. Currently we have one 3140 with both ISP's feeding into the router but obviously this creates a single point of failure. Is there any documentation on setting up a 3...
    poolet08
    last modified by poolet08
  • Out-of-band DTMF rfc2833 on 3140

    Hello. Does the Netvanta 3140 support rfc2833 out-of-band DTMF for SIP Trunking? I have enabled this option many times in Adtran 908 and so forth, but do not see the option in OS R13.2.2.   Typically, we use:&#...
    kylecci
    last modified by kylecci
  • Minimum AOS Firmware Version for Netflow?

    Good Day,   Checking to see what the minimum version of AOS is required for the 3140 to enable netflow.  I'm running R11.10.7.HA, which I think is too old.  I found the Excel AOS Feature Matrix for ver...
    kreynolds
    last modified by kreynolds
  • Is the 3140 going End-of-life?

    We purchase quite a few 3140's as demarc routers. My suppliers are telling me they are getting difficult to purchase, are they going EOL? If so, what is going to be the alternative is the price points of the 3140? Th...
    jlnoel94
    last modified by jlnoel94
  • 3120  top traffic statistics: is it worth using?

    I've got a 3120, and am wanting to know about this Top Traffic tool, and if it's a reliable tool to tell me if I've got devices utilizing a lot of the available bandwidth at a remote site.   Out of curiosity, d...
    rgouette
    last modified by rgouette
  • Can i monitor sip trunk usage on a 3140 SBC

    i want to know how many concurent call are made on my sip trunk, min / max
    patrickfrigon
    last modified by patrickfrigon
  • NV 3120 port forward from a specific public address

    I have many units setup however due to security needs  I have customers wanting ports open only from specific Public IP addresses. How do I accomplish this in the CLI.
    etdiego
    last modified by etdiego
  • SIP Proxy not working with VRRP VIP

    I am working on putting together a dual WAN, "high availability" topology with a pair of 3140's. This will be to support our hosted IP phones, leveraging the SIP proxy functionality. I am using VRRP on my LAN interfac...
    jander
    last modified by jander
  • How often should 3140 be rebooted?

    Coming up on 3 years, 16 weeks of uptime.  How often should the 3140 be rebooted?   I'm also on AOS R11.5.1.   Thanks, Kevin
    kreynolds
    last modified by kreynolds