DSU IV ESP AT Commands

Version 1
    Article ID: 1593
    Q&A

     

     

      DSU IV ESP AT Commands


     

    Q:

    DSU IV ESP AT Commands

     

     

    A:

    The following chart can also be found in the DSU IV ESP User Manual.

    CommandTitleDefault
    A/Re-execute Commandnone
    ATAAnswernone
    ATDnDial Numbernone
    ATEEcho Command1
    ATHHang Up Callnone
    ATOGo Onlinenone
    ATQnResult Code Display0
    ATSn?Read S-Registernone
    ATSn=xWrite to S-Registernone
    ATVnResult Code From Firmware1
    ATZSelf Testnone
    AT&CnCD Option0
    AT&DnTR Option0
    AT&FnRestore Factory Optionsnone
    AT&LnNetwork Type0
    AT&PnRemote Configuration
    AT&QnDTE Data Format0
    AT&RnCS Options0
    AT&Sn_CnSR Options0
    AT&Zn=xStore Phone Numbernone
    AT\NnError Control (V.34 DBU)0
    AT\QnFlow Control (V.34 DBU)
    AT\TnInactivity Timer
    AT%BnLoop Rate Select0
    AT%CnCompress Option (V.34 DBU)0
    CommandTitleDefault
    AT%KnDTE Rate Select
    AT%PPassword Control0
    AT%P=xPassword Entry0
    T%P>xPassword Verify0
    AT%RxInitiate Remote Config.
    AT%TnAnti-stream Option0
    AT_AnLLB Control0
    AT_BnDBU Number to Dial0
    AT_CnSR Control During Test0
    AT_DnRTS-CTS Delay0
    AT_EnDBU Originate/Answer0
    AT_FnScrambler Control0
    AT_GnDBU When OOS0
    AT_HnDBU When No RX Signal0
    AT_InDBU When No Sealing Current0
    AT_JnAuto Answer Enable/Disable0
    AT_KnDBU Enable/Disable0
    AT_LnDTE Routing Main/Backup0
    AT_N=xxSet Network Addressnone
    AT_PnFront Panel Enable/Disable0
    AT_RnRLB Enable/Disable0
    AT_S=xxSet Serial Numbernone
    AT_TnSelect Test Pattern0
    AT_XnClock Source Select0
    AT_YnSecondary Channel Rate Select0