ATLAS Factory Default Procedure

Version 2

    ATLAS Factory Default Procedure

     

    In order to factory default the ATLAS you will need a serial connection to the CRAFT port (on the ATLAS 830 it needs to be the back ADMIN port) with the following settings:

     

    Rate: 9600

    Data Bits: 8

    Parity: None

    Stop Bit: 1

    Flow Control: None

    Terminal Emulation: VT 100

     

    With the terminal session open, power up the ATLAS while holding in the front ACO button. In your terminal connection you should see:

     

    ATLAS 550 Boot ROM

     

                    Force Download

                                    Press [ENTER] to continue...

    (At this point you can release the ACO button.) Once you press [ENTER] you will see a menu. Using the arrow keys on your keyboard go down to "System Utility" and then right-arrow over and down to "Clear Config Memory". Press [ENTER] on this option’s "<+>" symbol. After this you will see:

     

      Confirm (y/n)

                    ** WARNING** This will clear the configuration memory and reboot!

    Press "y" to confirm, and the ATLAS will reboot with factory default settings. The LOGIN will then be "password".