Q: I am receiving the following error: "This BSC is not associated to a wireless regulatory domain. Click here to go to the AP setup to enter the authorization code". All radios are disabled. What is this code for and where can I obtain it?
A: Based on United States FCC and European DFS and ETSI regulations, ADTRAN requires customers to validate the country that Bluesocket Access Points are being operated in. The administrator must set the country to the proper country and then enter the corresponding authorization code under wireless>global. Please contact support for your country authentication code. If you are using Failover, you should set the country code on each BSC independently. If you are using Replication and you are not replicating the wireless tab you should set the country code on each BSC independently. If you are replicating the wireless tab, set the country code on the master and perform a snapshot from the nodes to replicate the country code to the nodes. If you are not using Bluesocket Access Points, it is not required you set the Country and you can instead disable the ap service under wireless>service to hide the red warning in the GUI.