cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
Anonymous
Not applicable

Adtran 830 and Quad E1 PRA Card

Hello:

I am trying to configure an Adtran 830 with Two Quad E1 PRA Cards and I am

getting no where.

The Cards are in Slot 1 and Slot 2. I have reseated the card several

times. I just upgraded the firmware to A.04 via TFTP and the system will

still not recognize the PRA Cards.

We moved the devices from region to region to support an upgrade and PBX

migration and need them to work in an E1 configuration.

Back of the 830 (Yes the cards are installed in the system, btw -- just the

pic was taken when I was reconnecting the mux)

​( We have two of these cards) and they are failing to register with the

system. No Lights on the front of the unit. I do not have the PRA cables

plugged in yet if that makes any difference.​

​The QUAD PRA Module type does not show up.

Any one have any ideas?

I have flashed the 830, cold restarted the system, reseated the cards and I

am at a loss on how to make this work.

Regards,

Matthew

0 Kudos
5 Replies
Anonymous
Not applicable

Re: Adtran 830 and Quad E1 PRA Card

The pictures did not show up in the post

pastedImage_0.png

pastedImage_1.png

pastedImage_2.png

Anonymous
Not applicable

Re: Adtran 830 and Quad E1 PRA Card

Thank you for using the ADTRAN Community Support Forum.

From your screen shots, if your E1/PRA modules are in slots 1 and 2, then the chassis is not detecting them at all. The modules should be detected whether the PRA cables are connected or not. You have an FXS module in slot 7 and a T1/PRI module in slot 8, so I suggest moving one of those to slots 1 & 2 in order to verify the slot DOES detect known working modules when they are put in those slots. If those modules are detected when they are moved to slots 1 and 2, then the chassis slots are good. If they are not detected then the chassis is bad, and you can try the other slots to determine which slots detect modules and which do not.

I would also suggest trying the E1/PRA modules in slots 7 & 8 to see if they are detected there. If you insert the E1/PRA module into slot 7 and Menu still shows it as an FXS-8, then the module is not being detected at all. If they are not, then modules have failed. You can look for a physical failure point, but that can be difficult.

The slot back-plane has pins that the module slides onto in order to make electrical connectivity. So if slots 1 and 2 do not detect any module, then it could be the pins are bent, or there is some other electrical fault on those slots. If the E1/PRA modules are not detected in any slot, there there is some kind of failure on the module.

Can you verify the part number of those E1/PRA modules?

Thank you,

Patrick

Anonymous
Not applicable

Re: Adtran 830 and Quad E1 PRA Card

The part number is 1200264L1

Anonymous
Not applicable

Re: Adtran 830 and Quad E1 PRA Card

Thank you. I wanted to verify, and that is an ATLAS E1/PRA module.

So either the modules are bad, or slots 1 & 2 on the chassis are bad.

Anonymous
Not applicable

Re: Adtran 830 and Quad E1 PRA Card

Since we haven't heard anything back from you, I'm going to mark this question as "assumed answered". If you have additional questions feel free to continue the discussion.