cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
mdecamps
New Contributor

Retiring Cisco 891 with adtran 908e 3rd generation but need to configure basic inside to outside NAT

I am replacing a Cisco 891 with an Adtran 908e 3rd gen; the issue I am having is with setting up an inside to outside nat on the Adtran. Below is a sample config of what's programmed on the Cisco I need to do the same on the Adtran 908e 3rd gen. The respective LAN and WAN ports on the adtran will be eth0/1(WAN) and the eth0/2 (LAN) any help would be greatly appreciated. thank you!

CISCO CONFIGURATION

Interface FastEthernet 0

description LAN

ip address x.x.x.x 255.255.255.0

ip nat inside

ip virtual-reassembly in

Interface FastEthernet 1

description WAN

ip address x.x.x.x 255.255.255.248

ip nat outside

ip virtual-reassembly in

duplex full

speed 100

ip nat inside source route-map NAT interface FastEthernet1 overload

access-list 1 permit any

route-map NAT permit 10

match ip address 1

match interface FastEthernet1

Labels (3)
0 Kudos