cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
kylem
New Contributor

All, we're having a strange issue where CID/CNAM information is not being passed to specific phone systems.

All, we're having a strange issue where CID/CNAM information is not being passed to specific phone systems. We have TDM going into TA6xx to hand off voice/data to customer.

I work for a CLEC/telecom. Here is the signal path from our switch to customer site.

Alcatel-Lucent Plexus 9000>Adtran TA4303>Adtran TA6XX> customer NEC PBX

The issue is restricted to customers getting an analog handoff from our gear. It only is affecting NEC phone systems, but there is a variety of models and firmwares. When a buttset is attached to the 66-block, the CID/CNAM is always displayed, yet only displays on the customer handsets about 60% of the time, defaulting to NO CALLER INFO or something similar. The customers that this is affecting had no issue of this type with their previous carrier.

Has anyone experienced anything similar?

0 Kudos
2 Replies
Anonymous
Not applicable

Re: All, we're having a strange issue where CID/CNAM information is not being passed to specific phone systems.

We've been having the same issue here with specific phone systems (around 50% calls with no caller-id even if we can see the callerid on the fluke testset):

- Cisco UC 560

- Avaya IP Office

We're delivering analog lines through a Netvanta 6310 with quad-fxs and octal-fxs cards.

No solution so far.. we've switched one Avaya to SIP trunks as a workaround.  We'll prolly open a case regarding this.  Will update if a fix is found.

jayh
Honored Contributor
Honored Contributor

Re: All, we're having a strange issue where CID/CNAM information is not being passed to specific phone systems.

Analog caller-ID is sent by Bell 202 1200-baud modem tones between the first and second rings. Possible intermittent failure modes may be timing (tone burst too soon after first ring so that AC ring voltage swamps the receiver) or level or twist of the modem tones. So I'd look at any configuration settings that might affect that. I'm not really familiar with the TA600 series, more of a TA900 guy. You might also play with impedance settings and TX levels on the FXS ports.

How old are these units? I have some VERY early notes on the TA900 that include the following, slight possibility it might be relevant:

"Adtran recently swapped power supplies in 904 because voltage to chip set responsible for generating caller-id was off by 2V. Supply was in-spec per manufacturer of chip set but they were getting intermittent caller ID. Remanufactured power supplies to bump up 2V to get into range; really big hassle."