cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
tho_vo
New Contributor

Adtran ATLAS 830 and Polycom Serial Gateway

Currently we have MGC 100 with MPI that connect to the Adtran 830 and inbound and outbound work perfectly fine, but when replacing MGC100 with RMX 2000  and Polycom serial gateway inbound does not work.  Outbound work perfectly fine, but inbound get a busy signal and the Adtran 830 display as user busy and unallocated number.  The serial gateway has a built in IVR, so shouldn't when an inbound call to the adtran should be routed to the Polycom serial gateway and play an IVR prompt.

Adtran 830-->Port 1 (Polycom Serial Gateway, built-in IVR)--> RMX 2000 (MCU)

Adtran 830 accept inbound number to port 1 (619-111-2222) directly connected to Polycom Serial Gateway port 1.

Polycom Serial Gateway use EIA-530A and RS-366

Adtran 830

(I see that * CTS *RTS *DTR on the DTE status)

Should I configure on the Polycom Serial Gateway to force the signal to look the same as the Adtran 830?  By default, the Polycom Serial Gateway only signaling is uncheck for force signaling. Please help me identify if any changes need to be done on the Adtran or the serial gateway.

0 Kudos
3 Replies
Anonymous
Not applicable

Re: Adtran ATLAS 830 and Polycom Serial Gateway

The RTS (request to send) and DTR (data terminal ready) are signals sent from the Polycom. The CTS (clear to send) is sent from the ATLAS.

It's been a while since I've gone over serial signaling, but with the Polycom sending RTS, I believe the ATLAS is seeing that as the Polycom trying to place an outbound call (and the ATLAS then sends CTS to give the "go ahead"), or at the very least "seizing" that port. So when the call comes in to 619-111-2222, the ATLAS sees that port as in use.

Hope this helps,

Patrick

tho_vo
New Contributor

Re: Adtran ATLAS 830 and Polycom Serial Gateway

So should I force the Polycom serial gateway to use RTS and DTR for signaling to match up with the ATLAS signaling?  Only inbound call is having this issue even when the ATLAS port is not in use

Anonymous
Not applicable

Re: Adtran ATLAS 830 and Polycom Serial Gateway

I'm not sure what you mean by "force the Polycom serial gateway to use RTS and DTR for signaling," but the ATLAS IS looking at these to determine when the Polycom is placing an outbound call, and when it is answering an inbound call. So the ATLAS needs these to be used "as needed" (at least the RTS) and not on at all times.