2 Replies Latest reply on Dec 14, 2017 2:18 PM by geo

Only able to set t1-rbs voice trunk role to "network", not "user"

baynetworks4life Nov 14, 2017 12:53 PM

I have tried on multiple Adtran TA devices to run the below, but always get a syntax error. Setting to "role network" allows me to create the trunk, but obviously it does not function as intended.

voice trunk T02 type t1-rbs supervision wink role user

Is there some other pre-configuration command that needs to be entered before I can set the role as user? I have tried on both 908E and 924E 2nd gen units. I am ripping my hair out and can't seem to find anything pertinent in the AOS reference - it indicates I should just be able to run the command.

Thanks!

Re: Only able to set t1-rbs voice trunk role to "network", not "user"

jayh Nov 15, 2017 1:37 AM (in response to baynetworks4life)

E&M wink RBS signaling is symmetrical. You should be able to bookend two TA900 units set for RBS wink role network to each other and have it work just fine, or one to a PBX, or one to a telco wink-start T1 RBS trunk. The word "network" in an RBS configuration is just a required keyword that really does nothing.

Specifically how is the trunk not performing as expected?
Like Show 0 Likes(0)

Actions
Re: Only able to set t1-rbs voice trunk role to "network", not "user"

geo Dec 14, 2017 2:18 PM (in response to baynetworks4life)

Hello Sawyer,

The only IP Business Gateway AOS device that supports Telco/PSTN facing CAS trunks is the NV 644 - it can do both USER and NETWORK role.
All other IPBG AOS devices only support NETWORK role for CAS trunks. The intended design is for the IPBG to act as the NETWORK for a PBX. Other than the NV 644, they are not intended to terminate PSTN CAS trunks or act as the USER for a PBX configured as NETWORK.

Regards,
Geoff
Like Show 0 Likes(0)

Actions

Go to original post

Legend

Correct Answers - 4 points