cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
lawesso
New Contributor

Dual PRI

Jump to solution

Hi,

     I need help setting up a dual PRI with two D channels. Inbound calls will start from the first PRI ascending and outbound call on the second one descending. In the back, I will have a cisco router with two T1 ports. Please advise.

0 Kudos
1 Solution

Accepted Solutions
Anonymous
Not applicable

Re: Dual PRI

Jump to solution

The ATLAS will accept inbound calls on either PRI. On the outbound PRI, make sure the OUT#ACCEPT is set to "$" (which is our wild-card to allow anything) with a Search of "Primary." The inbound PRI should either have an OUT#ACCEPT of "--" (in order to prevent any outbound calls on this PRI) or "$" with a Search of "Secondary." The search of "Secondary" indicates it should only be used once the "Primary" is either busy or out of service.

Hope this helps,

Patrick

View solution in original post

0 Kudos
2 Replies
Anonymous
Not applicable

Re: Dual PRI

Jump to solution

The ATLAS will accept inbound calls on either PRI. On the outbound PRI, make sure the OUT#ACCEPT is set to "$" (which is our wild-card to allow anything) with a Search of "Primary." The inbound PRI should either have an OUT#ACCEPT of "--" (in order to prevent any outbound calls on this PRI) or "$" with a Search of "Secondary." The search of "Secondary" indicates it should only be used once the "Primary" is either busy or out of service.

Hope this helps,

Patrick

0 Kudos
lawesso
New Contributor

Re: Dual PRI

Jump to solution

Thanks for the reply, your solution works.