4 Replies Latest reply on Feb 18, 2013 11:35 AM by david

    P2P tie trunk over IP

    dkee New Member

      Need config help replacing a P2P T1 on an older Siemens
      9006 switch with a VoIP connection over MetroE. Simply want to replace the
      physical T1 with an IP connection through the TA900's. Have worked with the old
      TA's but the new "Netvanta" type interface isn't clicking for me.
      Again just want T1 from Siemens convert to IP traverse MetroE IP into other
      side's TA900  then back out as T1 to remote shelf.

        • Re: P2P tie trunk over IP
          david Employee

          Dkee,

           

          Thanks for posting! The TA900 series is capable of converting E&M Wink or PRI over T-1 to SIP and then converting that back to E&M Wink or PRI over T-1 on the far end.  However, the TA900 will not support any other T-1 signaling protocol or any proprietary signaling across the T-1s.  Which signaling protocol will each end be using?

           

          Thanks,

          David

          • Re: P2P tie trunk over IP
            david Employee

            Dkee,

             

            Please let me know in a response if you need further assistance with this configuration.  Once we know more about the exact application, we would be happy to make recommendations or provide sample configurations.

             

            Thanks!

            David

            • Re: P2P tie trunk over IP
              david Employee

              Dkee,

               

              I went ahead and flagged this post as "Assumed Answered".  If the response on this thread assisted you, please mark it as Correct or Helpful as the case may be with the applicable buttons.  This will make it visible and help other members of the community find solutions more easily.  If you still need assistance, I would be more than happy to continue working with you on this - just let me know in a reply.

               

              Thanks!

              David

              • Re: P2P tie trunk over IP
                david Employee

                Dkee,

                 

                I went ahead and flagged the "Correct Answer" on this post to make it more visible and help other members of the community find solutions more easily. If you don't feel like the answer I marked was correct, feel free to come back to this post and unmark it and select another in its place with the applicable buttons.  If you still need assistance, we would be more than happy to continue working with you on this - just let us know in a reply.

                 

                Thanks,

                David