2 Replies Latest reply on Jul 30, 2012 11:21 AM by alfyj

    Has anyone used the monitor jacks on the Atlas 800 Quad  PRI module?

    alfyj New Member

      I have used the Altas 800 Quad PRI module a lot, but I have always used it with an External DSX for passive Monitoring with a T1 analyzer.  I am considering doing without the DSX in a new test environment, but I do not know how the monitor jacks on the Quad PRI module work.  There appears to be only one monitor jack for each T1, and I am used to using two monitor jacks on the DSX, one for In and one for Out.  If you are using it in DS1 DAX mode, you would have one jack on each T1 that is cross-connected through the Atlas matrix, so you would have one jack on each end, which would seem to be enough to see both sides of the connection.  But if you are using it in Dial Plan or in 1-0 DAX mode, how can I use the monitor jacks to see both the IN and the OUT side of the T1?