4 Replies Latest reply on Sep 5, 2013 1:04 PM by noor Branched from an earlier discussion.

    Trunking Between Netgear and NetVanta 1335

    ashish New Member

      Hi,

       

      I am really appreciated for your help. After upgrading the Adtran 1335 firmware version R10.8.0 issue has been resolved now. Adtran AP 160 is working fine.

       

      I have once more query. We need to configured VLAN in Adtran 135. This switch is new for me. can you please guide me how to configured vlan and How to connect L2 Netgear switch. Right now I have once 48 port netgear switch (model: gs748tps) and we have configured two vlan (Default VLAN and Voice VLAN) in netgear switch.

      We need to configured VLAN and routing in 1335 switch and connect netgear switch to Adtran 1335.

        • Re: Trunking Between Netgear and NetVanta 1335
          Employee

          ashish - I've branched your question to another thread as it is a new topic.

           

          The following guide explains how to set up VLANs on the 1335: Understanding the Switch Menu in the AOS Web Interface

           

          If you would like for the 1335 to be responsible for the routing between VLANs, then you can enable the VLAN interface option on the VLAN configuration page and assign each VLAN an IP address.

           

          When you are connecting to the Netgear, it is important to remember that the NetVanta only supports 802.1q encapsulation on its trunk ports. You will simply need to set up the port that connects to the Netgear as a trunk port after you have created all your VLANs and that should be it.

           

          Please do not hesitate to let us know if you have any further questions.

           

          Thanks,

          Noor

          • Re: Trunking Between Netgear and NetVanta 1335
            ashish New Member

            Thanks for the Support Noor, Sorry for the delay. We will try.

             

            Ashish

            • Re: Trunking Between Netgear and NetVanta 1335
              golden New Member

              netgear uses tagged/untagged for vlans like HP switches

              tagged is like trunk in Cisco/Adtran

              untagged is like an access port in Cisco/Adtran

              make sure your vlan is tagged for the port connected to the adtran and that the untagged port (netgear) is the native vlan on the Adtran port.

              • Re: Trunking Between Netgear and NetVanta 1335
                Employee

                ashish -

                I went ahead and flagged the "Correct Answer" on this post to make it more visible and help other members of the community find solutions more easily. If you don't feel like the answer I marked was correct, feel free to come back to this post to unmark it and select another in its place with the applicable buttons.  If you have any additional information on this that others may benefit from, please come back to this post to provide an update.  If you still need assistance, we would be more than happy to continue working with you on this - just let us know in a reply.

                 

                Thanks,

                Noor