5 Replies Latest reply on Aug 4, 2013 3:04 PM by chipgg

    I cannot access my MX410 through Telnet Ethernet or Craft, error indicates Telnet not available on host.  Is there a factory reset outside of the VT100 interface?

    chipgg New Member

      I have been using the Ethernet Telnet interface to configure the MX410.  I have been doing this for months now.  I set some PPP parameters in Network Management and the console hung.  Now I cannot initiate a Telnet session through the Ethernet or Craft interface.

       

      How do you reset the interface?  I power cycled the box without any luck.  Ideas?

       

      Thanks,