4 Replies Latest reply on Oct 17, 2013 2:03 PM by noor

    Interface eth 0/1

    davide New Member

      Where is physically located the interface eth 0/1 on the Adtran Netvanta 1638P  ?

        • Re: Interface eth 0/1
          vmaxdawg05 Past_Featured_Member

          To my knowledge, the 1638 switches only have Gigabit switch ports gigabit 0/1-48 and then the two high-speed interface slots.

           

          VLANs are assigned to switchports.  By default, all switch ports are in access mode on VLAN 1.  You have to create and enable VLAN interfaces and assign them as needed to the gigabit switch ports in order to have the equivalent of an ETH 0/1 interface on and of the 1500/1600 switches.

          • Re: Interface eth 0/1
            Employee

            davide - The NetVanta 1638 comes with a port labeled as MGMT on the chassis. This port is referred to as "int eth 0/1" in the CLI and web interface. Please do not hesitate to let us know if you have any further questions.

             

            Thanks,

            Noor

              • Re: Interface eth 0/1
                davide New Member

                Is it the MGMT interface just a management interface or I might route some data out of it ?

                  • Re: Interface eth 0/1
                    Employee

                    davide - It is meant to be used for management purposes. It is not a gigabit port like the other switchports on the 1638, but it is seen as its own routable interface in the route table. You could have a route configured to point out the MGMT interface as well.

                     

                    I hope that answers your question but please do not hesitate to let us know if you have any further questions.

                     

                    Thanks,

                    Noor