17 Replies Latest reply on Oct 6, 2014 2:21 PM by geo

    HELP!!! eth0/1 to eth0/2 SIP SBC with 908e?????

    rduncan New Member

      I have a Adtran 908e that I need to create a very simple SBC from SIP on eth0/1 to SIP on eth0/2... I am having problems and can not find anything on doing this.

       

      thanks!!!!

        • Re: HELP!!! eth0/1 to eth0/2 SIP SBC with 908e?????
          jayh Hall_of_Fame

          Do you need true SBC functionality or are you just needing NAT traversal and/or transparent proxy.

           

          Perhaps if you were to describe a bit more specifically what you are trying to accomplish it would help.

            • Re: HELP!!! eth0/1 to eth0/2 SIP SBC with 908e?????
              rduncan New Member

              I just need a trans proxy... I just want to pass the SIP traffic through from eth0/1 to eth0/2.... Sorry for being vague. Thanks for any help!!

                • Re: HELP!!! eth0/1 to eth0/2 SIP SBC with 908e?????
                  jayh Hall_of_Fame

                  Take a look at this for basics.  https://supportforums.adtran.com/docs/DOC-1826

                   

                  Is the unit in place now and you are adding SIP, or is it a new installation?  Will the TA908e be doing NAT for the LAN?  Are there IP phones connected to the PBX now, on the LAN?  The more information you give the community, the more help we can be. 

                    • Re: HELP!!! eth0/1 to eth0/2 SIP SBC with 908e?????
                      rduncan New Member

                      We currently have an openscape pbx going to a mediatrix the goes pri to the adtran that goes to the telecom... The mediatrix is freexing and taking out the phones daily... I am trying to find a cheap and easy way to get connectivity between us and the telecom via sip to sip connection... The current method is sip to pri to sip which is not good...

                       

                      I think that the openscape is failing to connect to the adtran as I got it to ring by just pluggin it into the adtran and calling in and out... Though there was not voice either way... Once rebooting the adtran the calling is now saying error.

                       

                      thanks,

                        • Re: HELP!!! eth0/1 to eth0/2 SIP SBC with 908e?????
                          rduncan New Member

                          Is there a way to register the adtran to the PBX? The PBX does not seem to want to send anything unless the endpoint is registered.

                           

                          thanks!!

                            • Re: HELP!!! eth0/1 to eth0/2 SIP SBC with 908e?????
                              jayh Hall_of_Fame

                              Yes, you can register the Adtran to the PBX (or the PBX to the Adtran if that's what you need).

                               

                              It sounds like the best configuration for your needs is to create two SIP trunks on the Adtran, one pointing to the carrier and one to the PBX.  Then build voice grouped-trunks to steer the calls appropriately.

                               

                              Each SIP trunk can be configured separately with whatever registration, codec, etc. is required by the other end.

                               

                              This is different from transparent proxy which would be for a SIP phone going through the TA908e to a hosted PBX as an example.

                                • Re: HELP!!! eth0/1 to eth0/2 SIP SBC with 908e?????
                                  rduncan New Member

                                  Sorry for my lack of knowledge, I did not put the system in, nor am I a telecoms guy lol... Story of every IT persons life I guess...

                                   

                                  Well, I have setup what you stated, two trunk groups and two trunk accounts routing to the sip servers. Do you know what the command to register the adtran to the pbx is? I don't seem to be figuring it out. I pasted the config below.

                                   

                                  ip firewall

                                  no ip firewall alg msn

                                  no ip firewall alg mszone

                                  no ip firewall alg h323

                                  !

                                  no dot11ap access-point-control

                                  !

                                  ip flow top-talkers

                                  !

                                  interface eth 0/1

                                    description Internal

                                    ip address  10.4.8.84  255.255.255.192

                                    media-gateway ip primary

                                    no awcp

                                    no shutdown

                                  !

                                  !

                                  interface eth 0/2

                                    description Ridgeville

                                    ip address  192.168.254.3  255.255.255.0

                                    media-gateway ip primary

                                    no awcp

                                    no shutdown

                                  !

                                  !

                                  !

                                  !

                                  interface t1 0/1

                                    shutdown

                                  !

                                  interface t1 0/2

                                    shutdown

                                  !

                                  interface t1 0/3

                                    tdm-group 1 timeslots 1-24 speed 64

                                    shutdown

                                  !

                                  interface t1 0/4

                                    tdm-group 1 timeslots 1-24 speed 64

                                    shutdown

                                  !

                                  !

                                  interface pri 1

                                    description Mediatrix-Top-PRI-2

                                    connect t1 0/3 tdm-group 1

                                    no shutdown

                                  !

                                  interface pri 2

                                    description Mediatrix-Bottom-PRI-2

                                    connect t1 0/4 tdm-group 1

                                    no shutdown

                                  !

                                  !

                                  interface fxs 0/1

                                    no shutdown

                                  !

                                  interface fxs 0/2

                                    no shutdown

                                  !

                                  interface fxs 0/3

                                    no shutdown

                                  !

                                  interface fxs 0/4

                                    no shutdown

                                  !

                                  interface fxs 0/5

                                    no shutdown

                                  !

                                  interface fxs 0/6

                                    no shutdown

                                  !

                                  interface fxs 0/7

                                    no shutdown

                                  !

                                  interface fxs 0/8

                                    no shutdown

                                  !

                                  !

                                  interface fxo 0/0

                                    no shutdown

                                  !

                                  !

                                  isdn-group 1

                                  !

                                  ip access-list extended ridgeville

                                    permit ip any  any     log

                                  !

                                  ip access-list extended web-acl-2

                                    remark ping

                                    permit icmp any  any  echo   log

                                  !

                                  !

                                  !

                                  !

                                  ip policy-class management

                                    allow list mgmt self stateless

                                  !

                                  ip policy-class ridgeville

                                    allow list web-acl-2 self

                                    allow list taco self stateless

                                    allow list ridgeville

                                  !

                                  !

                                  !

                                  ip route 0.0.0.0 0.0.0.0 10.4.8.65

                                  ip route 192.168.2.0 255.255.255.0 192.168.254.1

                                  !

                                  no tftp server

                                  no tftp server overwrite

                                  http server

                                  http secure-server

                                  no snmp agent

                                  no ip ftp server

                                  no ip scp server

                                  no ip sntp server

                                  !

                                  sip

                                  sip udp 5060

                                  sip tcp 5060

                                  !

                                  !

                                  !

                                  voice feature-mode network

                                  voice forward-mode network

                                  voice conferencing-mode local

                                  !

                                  !

                                  !

                                  !

                                  !

                                  !

                                  !

                                  !

                                  voice dial-plan 1 local NXX-NXX-XXXX

                                  !

                                  !

                                  !

                                  !

                                  voice codec-list PERMITTED_CODECS

                                    default

                                    codec g711ulaw

                                  !

                                  !

                                  !

                                  voice trunk T01 type sip

                                    description "Ridgeville"

                                    sip-server primary 192.168.2.2

                                    registrar primary 192.168.2.2

                                    codec-list PERMITTED_CODECS both

                                    update-supported

                                  !

                                  voice trunk T02 type sip

                                    description "OpenScape"

                                    sip-server primary 10.4.8.54 tcp

                                    registrar primary 10.4.8.54 tcp

                                  !

                                  !

                                  voice grouped-trunk RIDGEVILLE

                                    description "SIP Trunk to Ridgeville"

                                    trunk T01

                                    accept $ cost 0

                                  !

                                  !

                                  voice grouped-trunk OPENSCAPE

                                    description "PRI to OpenScape PBX"

                                    trunk T02

                                    accept $ cost 0

                                  !

                                  !

                                  !

                                  !

                                  !

                                  !

                                  !

                                  !

                                  !

                                  !

                                  !

                                  !

                                  no sip registrar authenticate

                                  !

                                  !

                                  sip proxy

                                  sip proxy transparent

                                  !

                                  !

                                  !

                                  !

                                  !

                                  !

                                  !

                                  !

                                  sip grammar from host local

                                  sip grammar p-asserted-identity host local

                                  !

                                  !

                                  !

                                  !

                                  no ip rtp firewall-traversal reuse-nat-ports

                                  !

                                  !

                                  sip secure remote-user

                                    no blacklist

                                  !

                                  !

                                  ip rtp quality-monitoring

                                  ip rtp quality-monitoring udp

                                  ip rtp quality-monitoring sip

                                  !

                                    • Re: HELP!!! eth0/1 to eth0/2 SIP SBC with 908e?????
                                      jayh Hall_of_Fame

                                      OK, what is working so far?  Is "Ridgeville" the incoming telco?  When you call the PBX number from the outside do you see incoming SIP invites?  Things are pretty confusing as both sides have private addresses.  Your default route seems to be on the subnet that you have labeled as "Internal", which seems odd.

                                       

                                      Is there a device at your site that is doing NAT between the incoming SIP trunk and the Adtran?

                                       

                                      Does the PBX expect to register to something, or does it want the incoming trunk to register to it? 

                                       

                                      You may need to get either a local consultant or someone from Adtran ACES to help you with this. 

                                      1 of 1 people found this helpful
                                        • Re: HELP!!! eth0/1 to eth0/2 SIP SBC with 908e?????
                                          rduncan New Member

                                          I have worked with Adtran and we have gotten it kinda working. We now have it routing calls in and out but voice traffic does not get routed out properly as there is no outgoing voice and any outgoing calls drop after 16 seconds. Very sketchy. The routing looks good, so we are stuck at that.... I am now looking at Yate and openSIP for alternatives to the SBC or anything to proxy the traffic.

                            • Re: HELP!!! eth0/1 to eth0/2 SIP SBC with 908e?????
                              rduncan New Member

                              This is between our PBX and the telephone company.