1 Reply Latest reply on Feb 11, 2015 8:20 AM by cj!

    Is it possible to configure two VRRP interfaces one on the LAN, and the other on the WAN?

    vmaxdawg05 Past_Featured_Member

      I have one WAN IP address from the ISP, and a few VLAN interfaces on the LAN side of my existing configuration.  I would like to configure VRRP for both the WAN and LAN side.  This way, I would only need the one WAN IP address and a single default gateway for each VLAN interface.  I haven't seen any configuration examples  like that, but would like to try it. 

        • Re: Is it possible to configure two VRRP interfaces one on the LAN, and the other on the WAN?
          cj! Beta_User

          Hi vmaxdawg05:

           

          Here's an example for VRRP on two interfaces.  It's not identical to your configuration.  In our case, 802.1Q sub-interfaces were required.  Another vendor manages the secondary device, so I only have config details for the primary VRRP device:

           

          interface eth 0/1

            encapsulation 802.1q

            no shutdown

          !

          interface eth 0/1.1

            description Default VLAN

            vlan-id 1 native

            ip address  192.168.1.32  255.255.255.0

            ip access-policy Private

            vrrp 1 description Data

            vrrp 1 ip 192.168.1.34

            no shutdown

          interface eth 0/1.7

            description Voice VLAN

            vlan-id 7

            ip address  172.16.1.32  255.255.255.0

            ip access-policy Private

            vrrp 2 description Voice

            vrrp 2 ip 172.16.1.34

            no shutdown

          !

          interface eth 0/2

            no ip address

            shutdown

          !

           

          Perhaps this will get you started.