1 Reply Latest reply on May 15, 2015 11:05 AM by geo

    ANI on PRI side of Adtran does not show up

    mcdeeiis New Member

      ANI shows up on SIP trunk but the PBX connected to PRI side of Adtran does not seem to receive the ANI. Where could be the problem?

       

      My Setup is as follows:

       

      TA908e

      Voip SIP trunk

      t 0/1 - Disabled

      t 0/2 - Disabled

      t 0/3 - Enabled - PRI (Wink)

      t 0/4 - Enabled - PRI (Wink)

       

      Any suggestions?

        • Re: ANI on PRI side of Adtran does not show up
          geo Employee

          Hello Deepak,

           

          Caller ID is only supported on Feature Group D (FGD) CAS E&M Trunks.  It is not available for Wink or Immediate.  On a FGD Trunk, The calling (ANI) and called party (DNIS) numbers both appear in DTMF format:      *ANI*DNIS*

           

          Regards,

          Geoff

          1 of 1 people found this helpful