2 Replies Latest reply on Jun 12, 2015 1:03 PM by john_in_nc

    Netvanta 7100 R11.4.2.E No ERL on GUI

    john_in_nc New Member

      I am trying to figure out what happened to my "Tune Analog Trunks" button for the Analog Trunk configuration on my 7100.

       

      I am able to run the command "test erl all auto-set" via CLI of my FXO interface config and I do get the result message but never see any changes made to the analog fxo  port.

      Has anyone else run into this problem?  I am running R11.4.2.E

       

      thanks