0 Replies Latest reply on Jun 25, 2015 2:34 PM by drjarmon

    How change n-command polling script?

    drjarmon New Member

      Getting checksum mismatch warnings.  It was determined that the command show file /start-config checksum needs to be show file startup-config checksum.  Where do you change this in n-command?

       

      AdtranNMS polling script needs to be updated:

       

      1. 2015.06.03 18:32:00 SSH:0> terminal length 0
      2. 2015.06.03 18:32:00 SSH:0> ena
      3. 2015.06.03 18:32:00 OPERATING_SYSTEM.SESSION User management ENABLE OK on portal SSH 0
      4. 2015.06.03 18:32:01 SSH:0> terminal length 0
      5. 2015.06.03 18:32:01 SSH:0> no events
      6. 2015.06.03 18:32:01 SSH:0> show cflash
      7. 2015.06.03 18:32:01 SSH:0> show version
      8. 2015.06.03 18:32:02 SSH:0> write memory
      9. 2015.06.03 18:32:03 SSH:0> show dynvoice-config checksum       ! Removed this command
      10. 2015.06.03 18:32:04 SSH:0> show running-config checksum
      11. 2015.06.03 18:32:05 SSH:0> show file /startup-config checksum  ! Change to: show startup-config checksum
      12. 2015.06.03 18:32:05 SSH:0> show flash exception-report*

       

      Thanks