3 Replies Latest reply on Aug 6, 2015 8:22 AM by cj!

    Configure QoS on 1238P

    getzjd New Member

      Hello,

       

      When configuring QoS on a 1335 or 1638, we have the following commands:

       

      qos queue-type wrr 25 25 25 expedite

      qos dscp-cos 46 to 7

       

      Then on each port we issue the qos trust cos command

      interface gigabit-switchport 0/17

      qos trust cos

       

      However, on a 1238, we cannot apply the qos trust cos commands to the ports.  My question is:  Are the following commands sufficient to apply QoS to the entire switch or is there additional configuration needed?

       

      qos queue-type wrr 25 25 25 expedite

      qos dscp-cos 46 to 7

       

      Thank you

        • Re: Configure QoS on 1238P
          cj! Beta_User

          Hi getzjd:

           

          According to the application note Configuring Ethernet Switch QoS and CoS in AOS (see page 2), the command qos trust cos is not available on NetVanta 123x switches.  The document explains that ingress CoS (or DSCP -> CoS) tags will be trusted.  If you need to assign a CoS tag for certain ports where ingress frames do not already have a priority, you may use the command qos default-cos <value>.

           

          Best regards,

          Chris

            • Re: Configure QoS on 1238P
              getzjd New Member

              So, if I read this correctly, being that our ShoreTel equipment is set for difserv 184 (46 decimal) then packets from the phones should be arriving tagged as 46.   Apply the commands below should then be all that I need to issue, correct?

               

              qos queue-type wrr 25 25 25 expedite

              qos dscp-cos 46 to 7