0 Replies Latest reply on Oct 27, 2015 9:00 AM by rpartee

    Adtran TA912 with a PRI & Analog Lines has wrong CID on Analog Lines

    rpartee New Member

      All,

       

      I have a Adtran TA912 which I am sending a PRI to a customer, but I also have analog lines built on it that go to separate customers.  I set the PRI up using Adtran's documentation on SIP-to-PRI.  The issue I am having is that the analog lines built on the device have the caller ID of the PRI's main line and not the CID of the actual FXS Analog Line.

       

      The PRI and the Analog Lines both have separate trunks and separate SBC IP's.

       

      Here is my doctored SIP config.  I can include more if necessary.  I also think that at first my PRI tries to send the call over T10 until it gets a 404-Forbidden and then tries the correct trunk.  Perhaps there is a different way to say which trunk gets which calls from the CID?

       

      voice trunk T01 type sip

        match ani "$" add p-asserted-identity "5152884400"

        sip-server primary 22.33.44.55

        max-number-calls 23

      !

      voice trunk T02 type isdn

        description "ABC-PRI"

        resource-selection linear ascending

        connect isdn-group 1

        no early-cut-through

        rtp delay-mode adaptive

      !

      voice trunk T10 type sip

        description "XYZCompany"

        sip-server primary 11.22.33.44

        registrar primary 11.22.33.44

        outbound-proxy primary 11.22.33.44

        max-number-calls 24

      !

      !

      voice grouped-trunk SIP-PRI

        trunk T01

        accept $ cost 0

      !

      !

      voice grouped-trunk PRI

        trunk T02

        accept 5152884400 cost 0

        accept 515288442X cost 0

        accept 515288443X cost 0

      !

      !

      voice grouped-trunk SIP

        trunk T10

        accept $ cost 0

       

      Does anyone have any thoughts?  Thanks for any help.