cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
Anonymous
Not applicable

Adtran TA908e PRI Clock Slave?

Jump to solution

I am testing this device for SIP-PRI to replace an end of life product and experimenting with troubleshooting methods that may come up. I am trying to set my TA908e's PRI to slave off of the PBX clock. I am using AOS R11.10.1.E. The manuals show that under the T1 interface that I should be able to put "clock source line" but the command does not apply (see below).

TA908e(config)#int t1 0/3

TA908e(config-t1 0/3)#clock source ?

system                 - Provide clock from chassis selection

Labels (2)
Tags (2)
0 Kudos
1 Solution

Accepted Solutions
dmozingo
New Contributor

Re: Adtran TA908e PRI Clock Slave?

Jump to solution

TA908e(config)#timing-source

internal               - Use internal clock source

t1                     - Recover clock from a T1 Interface

View solution in original post

1 Reply
dmozingo
New Contributor

Re: Adtran TA908e PRI Clock Slave?

Jump to solution

TA908e(config)#timing-source

internal               - Use internal clock source

t1                     - Recover clock from a T1 Interface