1 Reply Latest reply on Sep 20, 2016 10:35 AM by jay

    Connecting Netvanta 7060 to intercom

    kbauer New Member

      Hi all

       

      We're in the process of migrating to a Netvanta 7060 in one of the schools I manage, and I'm having some trouble trying to integrate the two way paging/intercom system that they use.

       

      Currently the intercom uses an analog phone, which triggers different pages (Public address, or two way calling between classrooms and the office) using a number of * codes. The phone that drives the system now is just a standard analog phone, but when you pick it up you don't get a standard dial tone.

       

      At any rate, I'd like to replace the old phone by integrating the system into the Netvanta. I was originally intending to patch the line into one of the FSX ports in the back, but I can't figure out how to set it up to get the phones to kick over to that line.

      Is there a way to set up a dial code that will activate a specific trunk or station port, even if there's no traditional dial tone, and without sending any keypresses? I'd like to activate the line on the phone, and then let them enter the specific code they want.

       

      I really appreciate any help you can give. Thanks!

        • Re: Connecting Netvanta 7060 to intercom
          jay Employee

          Ken, if you were plugging a phone into it, then the port on the intercom system was likely an FXS port, meaning you'd need to connect it to an FXO port on the 7100. You can create a trunk account for that FXO port and permit a certain number combination out of that trunk. The port should go off hook when that number combination is dialed. The only potential issue with that is that the system would then send the digits you dialed out the port. If that won't cause any problems with your paging system, that would be the best bet. Thanks

           

          Jay