cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
Anonymous
Not applicable

TA 904 PRI to SIP route by ANI (from pri)

Jump to solution

I have a TA904 (and several TA908's) and have setup multiple SIP trunks and a local pbx connected to a PRI  (trunk T10 on the TA

I would like to route outbound calls from the PRI out specific SIP trunks based on the callers source (ani OR cid)

So if I were to have seperate TN blocks one block would go out trunk T01 and the other TNs would use trunk T01.

So calls  from 1 555 444 124x  --> T01

and calls from 1 555 444 125x --> T02

I am not concerned with inbound paths just outbound

Is this possible and what do I need to do to configure this behavior ?

Labels (3)
0 Kudos
1 Solution

Accepted Solutions
jayh
Honored Contributor
Honored Contributor

Re: TA 904 PRI to SIP route by ANI (from pri)

Jump to solution

Very possible. It's called SABR (Source and ANI Based Routing). Specific configuration details here: Source and ANI Based Routing in AOS Voice Products

View solution in original post

0 Kudos
1 Reply
jayh
Honored Contributor
Honored Contributor

Re: TA 904 PRI to SIP route by ANI (from pri)

Jump to solution

Very possible. It's called SABR (Source and ANI Based Routing). Specific configuration details here: Source and ANI Based Routing in AOS Voice Products

0 Kudos