2 Replies Latest reply on Dec 28, 2017 5:29 PM by numagroup

    Active Chassis Configuration

    numagroup New Member

      I have 3 Netvanta 1638p switches which I'm configuring into a Active Chassis stack.  None have been configured with Activechassis mode enabled yet.  I have purchased the Activechassis modules and cables and ready to start the configuration.

       

      In the ActivChassis In AOS configuration guide the topology refers to 4 switches.

       

      My question is how to connect the cables with 3 switches?  I created the following diagram of how I am thinking the cables should go.

      • SW1 will be the master
      • SW2 will be the linecard
      • SW3 will be the backup

      Thanks,

      Alan

       

       

      Adtran 1638p Activechassis stack.png