0 Replies Latest reply on Feb 27, 2018 3:19 PM by burb72

    netvanta 6250 T1 rbs to SIP

    burb72 New Member

      I have a customer who has an Intervoice ivr to an adtran to covert to b8zs then across a T1 cas/rbs to a netvanta 6250.

      They can call into the sip side and it completes the call and pushes the call out the T1.

      The customer can not make outbound calls.

      Thanks in advance,

      Mike

       

      I see his digits come across then I get the following:

       

      ...( I see all 10 digits come in)

      18:03:47.560 TONESERVICES.EVENTS t1 0/4.22 - Dsp 0/1.3 - Tone Detection: received digit (1) event

      18:03:47.561 TRKPORT.00:04:22 00:04:22  Digit Received -1

      18:03:47.720 TONESERVICES.EVENTS t1 0/4.22 - Dsp 0/1.3 - Tone Detection: received digit (0) event

      18:03:47.721 TRKPORT.00:04:22 00:04:22  Digit Received -0

      18:03:51.721 TM.T06 22 GetDID - Tism_call(FAIL)

      ....

      interface t1 0/3

        description T1 to customer PBX (10 Digit DNIS)

        alias SPECTRUM_IF_ALIAS_113fdbfd

        tdm-group 1 timeslots 1-24 speed 64

        no shutdown

       

      interface t1 0/4

        description T1 to customer PBX

        alias SPECTRUM_IF_ALIAS_113fdbfe

        tdm-group 1 timeslots 1-24 speed 64

        no shutdown

       

      voice trunk T05 type t1-rbs supervision fgd role network

        description "T1 CAS to Customer PBX 10 Digit DNIS"

        fgd inbound-address

        connect t1 0/3 tdm-group 1

        rtp delay-mode adaptive

      !

      voice trunk T06 type t1-rbs supervision fgd role network

        description "T1 CAS to Customer PBX"

        resource-selection linear ascending

        fgd inbound-address

        connect t1 0/4 tdm-group 1

        match dnis "N$" substitute "$"

        rtp delay-mode adaptive

      voice grouped-trunk SIP

        resource-selection circular

        trunk T01

        trunk T02

        accept 1-XXX-XXX-XXXX cost 0

        accept XXX-XXX-XXXX cost 0

        accept 011$ cost 0

        accept $ cost 0  ( I added this just to make sure it would accept all numbers)

        reject NXX-976-XXXX

        reject 1-900-NXX-XXXX

        reject 1-976-NXX-XXXX

        permit list TDM

        !deny all other trunks

        !deny all other ani

       

      voice grouped-trunk TDM

        description "9 Digit DNIS TDM Trunk Group"

        trunk T06

        accept (a 10 digit number) cost 0

      (about 120 accept xxx-xxx-xxxx numbers)

      permit list SIP

        !deny all other trunks

        !deny all other ani