1 Reply Latest reply on Jul 23, 2018 12:33 PM by markfreeman

    Caller ID remove GRP_Prefix

    garabedy New Member

      I have a TA908e configured as FXS with inbound call Hunting. It appears as if this is causing the inbound Caller ID to display a GRP prefix before the Caller ID, GRP_NXX-NXX-XXXX . Is there any way to remove the GRP_ and display just the Caller ID?

        • Re: Caller ID remove GRP_Prefix
          markfreeman Employee

          sounds like you have a ring-group configured in your 908e

           

          go into the CLI of your unit and enter command

           

          TA900e#sh run voice ring-group verbose

          Building configuration...

          !

          !

          voice ring-group 1111

            type linear

            num-rings 2

            max-rolls 0

            max-inbound 1

            no coverage

            no did

            prefix "GRP"

          !

           

          you will see that there is a hidden command called prefix

           

          to remove it go into your ring-group and negate it, like this:

           

          TA900e#conf t

          TA900e(config)#voice ring-group 1111

           

           

          Configuring Existing Group "1111".

           

           

          TA900e(config-1111)#no prefix

          TA900e(config-1111)#do sh run voice ring-group ver

          Building configuration...

          !

          !

          voice ring-group 1111

            type linear

            num-rings 2

            max-rolls 0

            max-inbound 1

            no coverage

            no did

            no prefix

          !

          end

          TA900e(config-1111)#

           

          hope that helps.

           

          -Mark