1 Reply Latest reply on Jul 23, 2019 10:30 PM by jayh

    Need help setting up VLAN Swap for AT&T Fiber

    jasonsansone New Member

      I am attempting to make AT&T Fiber work without having to use the AT&T gateway.  One method is known as "vlan swapping" and is detailed here.  In order to attempt this method, I need to be able to set a VLAN id of 0 and also need to assign a cloned MAC to one of the ports on my switch.  I have Netvanta 1534 Gen 2 switches running the newest R13.4.0.SA firmware.  The GUI does not permit me to define a VLAN with ID 0.  Can this be done by CLI or any other means?  Also, is there any way to clone or manually program the MAC for a port?

        • Re: Need help setting up VLAN Swap for AT&T Fiber
          jayh Hall_of_Fame

          A VLAN ID of 0 is reserved and essentially denotes that there is no VLAN tag. The lack of a VLAN tag or native VLAN on a trunk will have a VLAN ID of 0x000. Its 802.1q field will have priority information only. To accomplish this, configure it as an access port or the native VLAN of a trunk port. Instructions to "set a VLAN id of 0" are poorly written and will be disallowed by most configuration parsers regardless of manufacturer. See: http://www.ismlab.usf.edu/dcom/Ch3_802.1Q-2005.pdf  page 76.

           

          You probably don't want  to manipulate the MAC of the physical switch port, but that of the layer 3 interface that will ARP for the IP. You do this at the interface level, which may be a VLAN interface in your case.

           

           

          (config)#interface ethernet 0/1
          (config-eth 0/1)#mac-address BA:DB:AD:C0:FF:EE